Barco ClickShare, Installation Manual

Page: 26 / 53

4. Installing ClickShare
To install the Base Unit in a 19 inch rack
1. Remove the four T10 torx screws at the bottom of the Base Unit.
Image 4-2
Removal of pre-mounted screws
2. Place the Base Unit on the rack mount and secure it by using the four T10 torx screws.
Refer to “1” on the fi gure below.
3. Fasten the antennae to the front panel of the rack mount.
Refer to “2” on the fi gure below.
1
2
3
3
2
1
Image 4-3
4. Tighten the antenna cables to the back of the Base Unit.
Refer to “3” on the fi gure above.
5. Use the four included screws to mount the rack mount into the rack.
16 R5900004 CLICKSHARE 21/08/2012