barbas Cuatro-7 75-60, Installation And Maintenance Manual

Page: 31 / 76

8 Installation in a new fireplace
8.1 Install the appliance - general procedure
1. Prepare the appliance. Refer to section 8.2 .
2. Install the appliance. Refer to section 8.3 .
3. Horizontally align the appliance. Refer to section 8.4 .
4. If applicable, make the electrical connection. Refer to section 8.5 .
5. Connect the flue gas pipe. Refer to section 8.6 .
6. If applicable, connect the external combustion air supply pipe. Refer to section 8.7 .
7. If applicable, connect the convection system. Refer to section 8.8 .
8. Install the NTC room temperature sensor (Opti-Air system only). Refer to section
8.11 .
9. Install the battery holder (Opti-Air system only). Refer to section 8.12 .
10. Insulate the appliance. Refer to section 8.9 .
11. Build the fireplace. Refer to section 8.10 .
12. Do a final check. Refer to section 8.13 .
8.2 Preparation for installation
Warning:
• The electrical connections must be made by a certified electrician.
• The optional convection ventilator and optional Opti-Air system both need a 230 VAC
electrical power supply near the installation location. Make sure to have a grounded
electrical power supply for the convection ventilator.
• Make sure the electrical connections can always be accessed.
• Make sure the door of the appliance opens and closes correctly.
• Make sure the baffles are in the correct position
• Make sure the control lever can move freely to left and to right. (Only for the appliance
without the Opti-Air system)
• Make sure the ashtray is empty.
8.3 Install the appliance
Caution: Do not lift the appliance with any kind of forklift. This will cause
damage to the underside of the appliance.
Caution: If the appliance is installed against a flammable rear and/or side
wall, precautions must be taken to prevent accidental fire. Refer to section 5.2
for a description of suitable precautions.
Installation in a new fireplace
Cuatro-7 75-60 31