B&R 8I84T200037.01P-1, User Manual

Page: 274 / 405

Programming guidelines
274 ACOPOSinverter P84 User's Manual 2.10
2.8.11.27 Transfer of configurations
Transfer of configurations to other inverter when using [MULTIMOTOR CONFIG.]
Example: A is the source, B is the target. In this example, configuration switching occurs via the logic input.
1. Connect the graphic display with inverter A
2. Set LI (
[config.1]
(CnF1) ) and LI (
[config. 2]
(CnF2) ) to 0.
3. Download configuration 0 in a file of the graphic terminals (Example: File 1 of the graphic terminals).
4. Set LI (
[config.1]
(CnF1) ) to 1 and leave LI (
[config. 2]
(CnF2) ) at 0.
5. Download configuration 1 in a file of the graphic terminals (Example: File 2 of the graphic terminals).
6. Set LI (
[config. 2]
(CnF2) ) to 1 and leave LI (
[config. 1]
(CnF1) ) at 1.
7. Download configuration 2 in a file of the graphic terminals (Example: File 3 of the graphic terminals).
8. Connect the graphic display with inverter B
9. Set LI (
[config.1]
(CnF1) ) and LI (
[config. 2]
(CnF2) ) to 0.
10.Set inverter B to the factory setting.
11.Upload the configuration file 0 onto the inverter (file 1 of graphic display terminal in this example).
12.Set LI (
[config.1]
(CnF1) ) to 1 and leave LI (
[config. 2]
(CnF2) ) at 0.
13.Upload the configuration file 1 onto the inverter (file 2 of graphic display terminal in this example).
14.Set LI (
[config. 2]
(CnF2) ) to 1 and leave LI (
[config. 1]
(CnF1) ) at 1.
15.Upload the configuration file 2 onto the inverter (file 3 of graphic display terminal in this example).
Note:
Steps 6, 7, 14 and 15 are only required if the function [MULTIMOTOR CONFIG] is used with three con-
figurations or three motors.
Network
Graphic display terminal
Current
Configuration
Terminal
[2 Configurations] (CnF1)
[3 Configurations] (CnF2)
Configuration 0
or Motor 0
Configuration 1
or Motor 1
Configuration 2
or Motor 2
CnF1 = 0, CnF2 = 0 CnF1 = 1, CnF2 = 0 CnF1 = 0, CnF2 = 1
or
CnF1 = 1, CnF2 = 1