B&R 8I84T200037.01P-1, User Manual

Page: 178 / 405

Programming guidelines
178 ACOPOSinverter P84 User's Manual 2.10
[CONFIGURATION R2] (r2)
Code Name/Description Setting range Factory settings
r2- [R2 CONFIGURATION]
r2 [R2 CONFIGURATION] [No] (nO)
Identical with R1 ( see "R1 CONFIGURATION" on page 176 ) with the following addition (display only for information purposes, as is selection can
only be configured from the [APPLICATION FCT.] (Fun-) menu):
bLC [BRAKE LOGIC] (bLC) : Control braking contactor
LLC [Line contactor assign] (LLC) :Control line contactor
OCC [Mot. cont.] (OCC) : Control downstream motor contactor
EbO [End wind.] (EbO) : End of winding ("Traverse control" function)
tSY [Sync Wobble] (tSY) : Synchronization "counter wobble"
dCO
[DC load]
(dCO) : Control pre-charge contactor DC bus
r2d [R2 Delay time] 0 to 60000 ms
1)
0
For the assignments [no fault] (FLt) , [BRAKE LOGIC] (bLC) , [Mot. cont.] (OCC) , [DC load] (dCO) and [Assign line cont] (LLC) the delay is
not adjustable and remains at 0.
The status change is only effective after the configured time as soon as the information is TRUE.
r2S
[R2 Active at] [1]
(POS)
Configuration of the function logic:
POS [1] (POS) : State 1 when the information is TRUE.
nEG [0] (nEG) : State 0 when the information is TRUE.
For the assignments [no fault] (FLt) , [BRAKE LOGIC] (bLC) , [DC load] (dCO) and [assign line cont] (LLC) the configuration [1] (POS) cannot
be changed.
r2H [R2 Holding time] 0 to 9999 ms 0
For the assignments [no fault] (FLt) , [BRAKE LOGIC] (bLC) , [DC load] (dCO) and [assign line cont] (LLC) the hold time is not adjustable
and remains at 0.
The status change is only effective after the configured time as soon as the information is UNTRUE.
1) 0 to 9999 ms then 10.00 to 60.00 s on the integrated display terminal.