baltur BTG 20 LX, Instructions For Use Manual, Page: 45 / 116

15 / 28
0006080937_2010/03
E
N
G
L
I
S
H
MAINTENANCE
1) Undo the lid screw “A” to gain access to the
interior of the burner.
2) After disconnecting the gas train, unscrew the 3 screws
“B” that fasten the flange of the gas outlet connector to
the burner plate.
3) Remove the mixer unit in the picture.
0002934360B
0002934250A
0002934360C
The burner does not require special maintenance, but it is good practice to check periodically that the gas filter is clean and that the
ignition electrode is efficient. It is also necessary to verify that the ignition electrode’s spark is produced between the same electrode
and the disk. The combustion head may need cleaning. Take care during re-assembly to exactly centre the electrodes (one for switching
on and one for flame detection) to prevent these going to ground and blocking the burner. Most of the components can be inspected by
removing the housing; to inspect the head you must remove the mixing unit, proceeding as explained below.
B B B