baltur BTG 20 LX, Instructions For Use Manual

Page: 44 / 116

14 /28.
0006080937_2010/03
E
N
G
L
I
S
H
ELECTRODES ADJUSTMENT DIAGRAM N° 0002934181
REV.:26/05/2004
1 Ionisation electrode
2 Ignition electrode
3 Flame disk
4 Gas diffuser
5 Gas delivery pipe
USE OF THE BURNER
The burner operates fully automatically, therefore it is non necessary to carry out any kind at adjustment during its operating. The “block”
position is a safety position reached by the burner automatically when some of the components of the burners or the plant do not work
properly. It is necessary to check then whether the cause to the problem is a dangerous one before unblocking the burner. The causes to
the block may be temporary, for example when air in inside the pipes. When it is unblocked, the burner starts operating properly.
If the burner stops three or four times at a stretch, it is necessary either to loock for the problem and solve it or ask for the intervention of
the after sales service.The burner can remain in the “block” position without any limit in time.
In emergency cases it is advisable to close the fuel valve, and to disconnect the burner electrically.
FAN ASSEMBLY DIAGRAM
N° 0002934150
REV.:26/05/2004
- Observe the measurements indicated in the diagram when fitting the fan.
BTG 20Lx
A B C
5 2÷3 8,5