Balluff BIP LD2-T017-04-BP S4 Series, User Manual

Page: 39 / 142

6
IO-Link interface (continued)
Returning measuring range settings to factory
default
Index Subindex Access Value
Hex. Dec. Hex. Dec.
1. Activate the measuring range settings
(address 0xC0/192
10
).
003A 58 00 0 Write only 0xC0
2. Return all measuring range settings to the factory settings
1)
. 0002 2 00 0 Write only 0x4E
1)
See chapter Factory settings on page 17
6.13 Factory settings
The following settings exist at the time of delivery and after
resetting to factory settings:
Binary data channel factory settings
Parameters BDC1…3 Comment
Hex. Dec.
Setpoint SP1 0000 0 Switching threshold value
Setpoint SP2 0000 0 Functionally not supported
Switch point mode 00 0 Inactive
Switch point logic 00 0 Switching state NO (normally open)
Switch point hysteresis 0064 100 Default value corresponds to a digital output value of 100.
Tab. 6-12: Factory settings (binary data channel)
Measuring range factory settings
Parameters Index Subindex Data
format
Default value Comment
Hex. Dec. Hex. Dec. Hex. Dec.
Slmin 00C8 200 01 1 UINT16 0000 0 Starting point of curve
Slmax 00C8 200 02 2 UINT16 0FFF 4095 End point of curve
Inversion 00C5 197 00 0 UCHAR8 00 0 Non-inverted curve
Tab. 6-13: Factory settings (measuring range)
Reset to factory settings
All sensor parameters can be reset together.
To reset the settings separately, see Returning all switching
channel settings to factory default on page 16 or
Returning measuring range settings to factory default on
page 17.
Index Subindex Access Value
Hex. Dec. Hex. Dec.
►
Return all settings (BDC and measuring range) to factory
default.
0002 2 00 0 Write only 0x82
www.balluff.com 17 english
BIP LD2-T017-04-BP _ _ / BP _ _ -S4
Inductive Positioning System