Balluff BIP LD2-T017-04-BP S4 Series, User Manual, Page: 35 / 142

6
IO-Link interface (continued)
6.7 System commands
Index Subindex Parameters Data
format
Access Value
range
Comments
Hex. Dec. Hex. Dec.
0002 2 00 0 System
command
UINT8 Write
only
0x4B Teaching
Slmin/
Slmax
Temporarily saves the current
position as Slmin.
0x4C Saves the current position as
Slmax.
0x4D Applies the Slmin/Slmax values.
0x4F Deletes the temporarily saved
values.
0x4E Resets all settings of the selected
channel to the default values.
0x82 Reset Reset to factory settings
Tab. 6-8: System commands
6.8 Profile-specific parameters
Index Parameters Sub-index Parameters Data
format
Access Value range Comments
Hex. Dec. Hex. Dec. Hex. Dec.
003A 58 Teach-In
channel
00 0 UINT8 Read/
Write
00 0 BDC1
(default)
01…03 1…3 BDC1…BDC3
003B 59 Teach-In
status
00 0 UINT8 Read only See Smart Sensor Profile
(www.io-link.com)
003C 60 Set Point
value (BDC1)
01 1 Setpoint SP1 UINT16 Read/
Write
00…0FFF 0…4095
02 2 Setpoint SP2 0 0 Functionally not
supported
003D 61 Switch Point
configuration
(BDC1)
01 1 Switchpoint logic UINT8 Read/
Write
00…01 0…1
02 2 Switchpoint mode 00…01 0…1
03 3 Switchpoint
hysteresis
UINT16 ≥0013 ≥19 Smallest
hysteresis value
003E 62 Set Point
value (BDC2)
01 1 Setpoint SP1 UINT16 Read/
Write
00…0FFF 0…4000
02 2 Setpoint SP2 0 0 Functionally not
supported
003F 63 Switch Point
configuration
(BDC2)
01 1 Switchpoint logic UINT8 Read/
Write
00…01 0…1
02 3 Switchpoint mode 00…01 0…1 BDC activated
03 3 Switchpoint
hysteresis
UINT16 ≥0013 ≥19 Smallest
hysteresis value
4000 16384 Set Point
value (BDC3)
01 1 Setpoint SP1 UINT16 Read/
Write
00…0FFF 0…4095
02 2 Setpoint SP2 0 0 Functionally not
supported
4001 16385 Switch Point
configuration
(BDC3)
01 1 Switchpoint logic UINT8 Read/
Write
00…01 0…1
02 2 Switchpoint mode 00…01 0…1
03 3 Switchpoint
hysteresis
UINT16 ≥0013 ≥19 Smallest
hysteresis value
Tab. 6-9: Profile-specific parameters
www.balluff.com 13 english
BIP LD2-T017-04-BP _ _ / BP _ _ -S4
Inductive Positioning System