Balluff BIP LD2-T017-04-BP S4 Series, User Manual, Page: 38 / 142

6
IO-Link interface (continued)
Index assignment of switching channels
Channel number Assigned channel Comment
0 (0x00) BDC1 Binary data channel 0 ( default )
1 (0x01) BDC1 Binary data channel 1 (Bit 0 in PD)
2 (0x02) BDC2 Binary data channel 2 (Bit 1 in PD)
3 (0x03) BDC3 Binary data channel 3 (Bit 2 in PD)
255 (0xFF) BDC1…3 Return all switching channel settings to factory default.
Tab. 6-11: Index assignment of switching channels
Returning all switching channel settings to factory
default
Index Subindex Access Value
Hex. Dec. Hex. Dec.
1.
Select switching channel. 003A 58 00 0 Write only Channel number 1)
2. Return all settings of the previously selected switching
channel to factory settings
2)
.
0002 2 00 0 Write only 0x4E
1)
See Tab. 6-11 on page 16, hexadecimal value
2)
See chapter Factory settings on page 17
6.12 Teach-in of the measuring range
The start and end points of the curve (Slmin and Slmax)
can be defined by teaching in to indicate the gradient
progress and gradient value of the curve.
Teach-in process of the measuring range
Index Subindex Access Value
Hex. Dec. Hex. Dec.
1. Activate the measuring range settings
(address 0xC0/192
10
).
003A 58 00 0 Write only 0xC0
2.
Move target to new Slmin.
3)
3. Temporarily save the current distance as Slmin. 0002 2 00 0 Write only 0x4B
4.
Move target to new Slmax.
4)
5. Temporarily save the current distance as Slmax. 0002 2 00 0 Write only 0x4C
6.
Apply and activate values for the new measuring range Slmin/
Slmax.
0002 2 00 0 Write only 0x4D
3)
Within the original linear range
4)
Within the original linear range and at least 5.7 mm
The teach-in process has no time limit.
The minimum distance between start and end point must
be set to a value greater than 1/3 Slmax.
The Slmin start point value must always be smaller than
Slmax.
The start point Slmin is initially saved temporarily and can
then be overwritten any number of times.
If the target leaves the measuring range during
teach-in, the error message
TEACH_STATE_ERROR is shown.
If the measuring range is changed by teach-in, any
previously saved switching positions (BDCs) are deleted.
The new curve offset and gradient value set by teach-in
can be read out as described in Tab. 6-7 on page 12.
16 english
BIP LD2-T017-04-BP _ _ / BP _ _ -S4
Inductive Positioning System