Baldan CRI, Instruction Manual

Page: 25 / 68

When assembling the disc sections on the frames, note that the
frame slabs should face the discs' concavity.
ATTENTION

After securing the front and rear frames to the upright, make the securing of disc
sections to do this, proceed as follows:
01 - Lift the front or rear of the harrow and place the disc section (3) in line and match
the drilling of the slabs (4) with the bearings and secure them with screws (5), plain
washers (6) and nuts and locknuts (7).
02 - Then, lift the other part of the harrow and repeat the operation by checking the
concavity of the discs from one section to the other that should be opposite.
03 - When finishing the assembly, check that the slabs (4) are facing the concavity of the
discs.
4
4
3
5
1
3
1
2
7
6
Instruction Manual