Baldan CRI, Instruction Manual

Page: 34 / 68

3
1
2

To level the CRI , proceed as follows:
01 - Place the tractor and CRI in a flat location.
02 - Then raise the lift to the railing and see if the CRI is positioned in the front or rear
position.
CRI POSITIONED IN THE REAR
CRI POSITIONED ON THE FRONT
If the CRI is positioned in the front or rear, proceed as follows:
01 - Lower the CRI until it is completely on the ground.
02 - Then, loosen the lock (1), flat washer (2) and remove the pin (3).
03 - Then adjust another point on the stabilizer bar (4) and secure it again.
04 - Lift the CRI and check that the harrow is level as shown on the following page.
4
Instruction Manual