COMPONENT DESCRIPTION AND REPLACEMENT
OPERATOR INTERFACE DEVICES
I-E96-192-5A
6 - 23
IIOIC422 CONSOLE MODEL
To remove the monitor from an IIOIC422 console:
1. In the front of the cabinet, turn off the main circuit breaker
on the power entry panel to shut off power to the OIC console.
Check the power indicator to see if power is removed from the
system.
2. In the rear of the cabinet, remove the power cord and RGB
cable from the rear of the monitor. Secure the RGB cable out of
the way.
3. Remove the bolt on each side of the monitor mounting tray
at the rear of the monitor. These bolts attach the tray to the
cabinet shelf.
4. Slide the monitor out of the cabinet.
5. After removal, place the monitor and tray onto a solid, flat
surface.
6. Protect the screen of the monitor and set the screen down
on the protective surface.
7. Remove the monitor from the mounting tray by removing
the four screws under the tray.
8. Before installing a new monitor, make certain the resistor
switches are set to
resistor
to insure that the termination is
set for 75 ohms and that the VGA sync switch is set to
GRN
IIOIC423 ENVIRONMENTAL MODEL
To remove a monitor from an IIOIC423 environmental console:
1. Open the front door and turn off the main circuit breaker
on the power entry panel. Check the power indicator to see if
power is removed.
WARNING
The monitor will slide out the rear of the cabinet by itself when
the mounting bolts are removed. The monitor weighs approxi-
mately 27 kilograms (60 pounds) and can cause bodily injury if
it is allowed to slide out by itself. Support the monitor before
removing the rear two bolts.
AVERTISSEMENT
Supportez le moniteur avant de retirer les deux boulons
d'ancrange à l'arriér. Lorsque ces boulons d'ancrage sont
retirés, l'e moniteur glissera et sorta à l'arriér de l'armoire. l'e
moniteur pése environ 27 kilograms (60 pounds) et pourrait
entrainer des blessures si on le laisse glisser de l'armoire.
