0019-9376
Revision 0
8
Monoxor
®
XR User Manual
An ambient CO feature takes approximately 15-minutes to complete and provides a minute-
by-minute snapshot of CO readings, as well as a “Max CO” value that represents the highest
CO reading measured during the entire test. Results can be saved to memory and/or printed.
A calibration reminder can be set to occur every 6, 8, 10, 12, or 15-months after the last
calibration.
(Select “Never” to disable this feature.)
Regular calibration periods of 6 months to 1
year are recommended. The calibration reminder value sets a time period after which the
analyzer displays a calibration reminder message during warm-up.
To avoid the need for manual CO sensor calibrations, the B-Smart
®
Sensor program is
supported with the Monoxor
®
XR. After enrolling in the program, pre-calibrated replacement
B-Smart
®
CO sensors are shipped at predetermined intervals of your choice.
• Choose a program start date that best suites your needs.
• Receive a pre-calibrated B-Smart
®
sensor.
• Return your old sensor in a returnable, pre-labeled container.
Benefits include no downtime, self calibration, convenience, and cost savings. For additional
information about the B-Smart
®
Calibration Program, contact Bacharach at 1-800-736-4666
or email [email protected].
A programmable inactivity timeout causes the analyzer to initiate shutdown mode if no key
presses occur for the specified time period. If the analyzer initiates automatic shutdown or
is turned OFF manually while a high level of CO is still present within the unit, the automatic
CO purge feature forces the analyzer’s pump to remain on until the detected CO level drops
below 50 ppm.
The instrument is supplied with the following components:
• Probe and hose assembly
• Four disposable “AA” alkaline batteries
• Hard carrying case
• Factory-calibrated and installed CO sensor
Depending on the model and kit, some or all of the following components are included:
•
Spare filters
• Fyrite
®
User Software
(FUS)
• USB cable
(type A to mini B)
• Infrared Data Association
(IrDA)
printer with four disposable “AA” alkaline batteries
• Printer paper
Using the optional thermocouples, ambient and flue gas temperatures can be measured.
Additionally, the Monoxor
®
XR can calculate a differential temperature based on two
sampled temperatures
(T1 and T2)
using the optional stack thermocouple or optional probe
assembly
(with built-in thermocouple)
. After you take the two sample readings, the differential
value
(T1-T2)
is calculated, optionally saved in memory, displayed on the main run screen,
and is shown on printouts.
