Avocent AutoView 200, Installer/User Manual, Page: 21 / 60

Chapter 2: Installation
15
5. If your extended access location utilizes Sun peripherals, you will need to
set the AutoView 400 to recognize them before they can be used. To do this:
a. Activate the OSD by pressing Control twice within one second.
b. Press Control twice more to access Administrator Commands.
c. Use your Arrow keys to highlight Administrator Functions and press Enter .
d. Highlight Remote User . Use the Spacebar to cycle through peripheral
types and select the ones appropriate to your system. Press Enter .
6. Connect the CAT 5 cable to the modular jack on the rear of the receiver.
7. Connect the circular power plug from the wall mount power supply to the
power port on the LongView receiver. Then plug the power supply into a
convenient electrical outlet. Verify that the receiver’s power LED is now lit.
The AutoView 400 and all attached computers should be powered down before
servicing the unit. Always disconnect the power cord from the wall outlet.