AVL AVL DiCom 4000, Service Manual

Page: 45 / 182

4000 Evaluation Unit
Service Manual 4-13
4.5 Printer
A hardcopy can be printed out of all the measurement results displayed. The official
measurements end with an official results printout.
4.5.1 Internal Printer Unit (Option/Installation)
It takes about 30 seconds to printout a hardcopy. A results printout takes ½ to 1 minute
depending on how long it is. During this time, none of the instrument’s functions can be
activated.
Technical data:
−
Seiko Epson, model M-181
−
6-needle miniature printer for normal paper
−
max. 30 chars per line (5
×
7 matrix)
−
average speed 1.3 lines/sec
−
180 pixels per pixel line in graphics mode
−
carbon copy possible
−
paper width approx. 57.5 mm
−
typical service life > 1 million characters
−
typical service life of long-life ribbon 1 million characters (violet), 600 000
characters (black)
The printer option (ident. number BO1720) consists of the following components:
−
printer adapter BB0279
−
printer cable (for printers with connection cable) BV1983
−
paper shaft YM3388
−
paper roll for dot matrix printer HP0057
−
3 metal screws DS1101
Instructions for conversion
•
Switch off the instrument and disconnect the mains plug.
•
Open the instrument completely.
•
Insert the printer adapter onto the main board (slots J27 and J28).
•
Remove the plastic cover at the front of the instrument
•
Pull the fixing shaft out of the printer‘s plastic cover.
•
Connect the connection cable to the printer adapter.
•
Fasten printer in position with the 3 metal screws.
•
Enter the printer option on the options sticker.
•
Reassemble the instrument.
•
Plug the mains cable back in and switch on again.
•
Insert the paper roll and push the paper through.