Avaya 2050 IP Softphone Settings
84
Server
Use the Server dialog box to configure the connection between the
Avaya 2050 IP Softphone and your communications server and, if
applicable, the GXAS server. You can either use the default method
(DHCP) or manually specify an IP address.
To open the
Server
dialog box, select
Server
from the list in the left pane
of the Settings window.
The following sections describe the Server settings:
•
“Reset button” on page 84
•
“Using IP addresses and DNS names” on page 85
•
“Restoring defaults” on page 85
•
“Resetting the connection” on page 86
Reset button
When you select the
Reset
button in the following procedures, the phone
resets immediately without any warning.
However, if you make a change to the settings and select
Apply
or
OK
,
the phone indicates that a reset needs to take place. A warning message
appears—"Avaya 2050 IP Softphone must reset for the configuration
changes to be complete. Select Yes to reset now or select No if you plan
on resetting later". You can select
Yes
to reset now, or
No
, to defer it until
later.
Using DHCP
With
Automatic (DHCP)
enabled, the Avaya 2050 IP Softphone reads
server addresses from a Dynamic Host Configuration Protocol (DHCP)
server.
Note:
To use DHCP, your Local Area Network (LAN) must include a
DCHP server. Contact your System Administrator to configure the
server with the correct IP address values.
Summary of Contents for IP Office 2050
Page 6: ...6 ...
Page 18: ...18 ...
Page 132: ...Troubleshooting the Avaya 2050 IP Softphone 132 ...
Page 142: ...Index 142 ...
