AUX ASW-H09A4/EAR1-dw, Service Manual

Page: 41 / 76

- 39 -
the corresponding primary position. The primary position for Heating mode is the position
5(Picture 3), for Cooling mode is the position 2 (Picture 3).
③
The “Swing” button on the remote controller can set the Horizontal air-blade to be swing
Automatically or not
；
④
The maximum swing angle of automatic swing under Heating mode is 40°
，
e.g. the angle
between 3-5 in picture 3
；
the angle under Cooling mode is 40°e.g. the angle between 2-4
；
The swinging speed is 1step/16ms;
⑤
When the indoor fan stops operation, if the setting swinging mode set by the remote control
is automatic swinging, the Horizontal air-blade will turn to the corresponding position and to
be orientated. For example: the corresponding position under Cooling mode is position
2(Picture 3), for Heating mode is position 5(Picture 3), resume the automatic Swing once the
fan motor starts; if the setting swing mode is Manual, the swing angle of the Horizontal
air-blade will never change
；
⑥
After turning off the air-conditioner and stopping the running of the indoor fan, the air door
will shut off automatically;
⑦
Enter into the Auto-run mode by pressing the Emergency switch, the setting status of the air
door is in accordance with the Cooling mode, and will be adjusted again after the new mode is
selected.
(Picture3)
⒁
Wind speed option function
18000BTU-24000BTU are RP plastic-sealed motor
，
the rotate speed can not be controlled
by the PCB.
⒂
Optional functions
The below functions’ programs are already write into the Main chip of the PCB, and can be
performed if only the corresponding hardware is available. For example: the E
2
CMOS chip
is in need for the Auto-restart function, the corresponding remote control is in need for the I
feel function, and the relay is in need for the Negative ion function.
①
Auto-restart control function