DL205 User Manual, 4th Edition, Rev. B
5–338
Chapter 5: Intelligent Box (IBox) Instructions
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
CTRIO Edit Preset Table Entry (CTREDPT) (IB-1003)
CTRIO Edit Preset Table Entry, on a leading edge transition to this IBox, will edit a single
entry in a Preset Table on a specific CTRIO Output resource. This IBox is good if you are
editing more than one entry in a file at a time.
If you wish to do just one edit and then reload
the table immediately, see the CTRIO Edit
and Reload Preset Table Entry (CTREDRL)
IBox.
This IBox will take more than one PLC scan to
execute. Either the Success or Error bit will
turn on when the command is complete. If the
Error Bit is on, you can use the CTRIO Read
Error Code (CTRRDER) IBox to get extended
error information.
Entry Type:
K0: Set
K1: Reset
K2: Pulse On (uses Pulse Time)
K3: Pulse Off (uses Pulse Time)
K4: Toggle
K5: Reset Count
Note that the Pulse Time parameter is ignored by some Entry Types.
The Workspace register is for internal use by this IBox instruction and MUST NOT be used
anywhere else in your program.
CTREDPT Parameters
• CTRIO#: specifies a specific CTRIO module based on a user defined number (see CTRIO Config
Ibox)
• Output#: specifies a CTRIO output to be used by the instruction
• Table#: specifies the Table number of which an Entry is to be edited
• Entry#: specifies the Entry location in the Preset Table to be edited
• Entry Type: specifies the Entry Type to add during the edit
• Pulse Time: specifies a pulse time in msecs for the Pulse On and Pulse Off Entry Types
• Preset Count: specifies an initial count value to begin at after Reset
• Workspace: specifies a V-memory location that will be used by the instruction
• Success: specifies a bit that will turn on once the instruction has successfully completed
• Error: specifies a bit that will turn on if the instruction does not complete successfully
DS5
Used
HPP
N/A
ý
ý
þ
þ
230
240
2
5
0
-1
2
6
0
