12
Axess® Pro Series 3000
Owner Installation Instructions
Installation
08
fi g
Step 3 - Mounting The Drive Unit
Open the shutter about one metre from the fl oor.
Raise the drive unit to the required height by using a
suitable lifter or use chain block connected to a secure
beam above the door axle.
Position opener and secure with four M12x30
screws.
Mount drive sprocket on shaft in line with door
drive gear. Tighten the grub screw on the
sprocket with M4 hex key.
Shorten drive chain as required and fi t around
drive gears.
Feed manual chain through guide and over the
clutch pulley.
Shorten chain as required and fi x ends to make a
loop.
NOTE:
ensure that hand chain is not twisted when
making a loop.
Step 4 - Installing The Wall Control Unit
Remove the main cover.
Affi x the wall control unit at a height of 1.5
metres within sight of the door. Make sure that
the position of the wall control unit is out of reach
of children and convenient to the customer
(Fig.
08)
.
Replace the main cover.
WARNING! Do not turn the power on to the
opener before connecting the wall control
unit.
WARNING! Ensure that communication cable
is affi xed properly and away from the moving
parts of the door and opener.
NOTE:
5 metre communication cable is supplied with
the opener.
1.
2.
3.
4.
5.
a.
b.
c.
