27
FIRST SETTINGS ADJUSTMENT AND CHOOSING
OF THE OPTIONS
Initial setting of the PIN-code
1. Ensure that the ignition is turned on, the red and
the gray wires are connected to a permanent «plus»,
the device is in the PIN-code change mode (the
indication signal is being repeated once in three
seconds).
2. Enter the PIN-code using the buttons available for
programming (see the official service website of the
company https://service.author-alarm.com/).
Each push of the button will be accompanied by the
respective indication signal.
The number of pushes
should be from 3 to 20. The time gap between the
pushes should not exceed 2 seconds. There is no
difference between long and short pushes. Different
buttons combinations may be used.
After the PIN-code has been entered the system will
provide three indication signals.
3. Enter the PIN-code once again. The system will
confirm correctness of the entered PIN-code by two
indication signals. The entered PIN-code will be
saved in the memory of the device.
If there provided four indication signals, this connotes
that the two entered PIN-codes have not matched. In
this case the PIN-code will not be saved, turn off the
ignition and repeat the points from 1 to 3.
4. Turn off the ignition.
5. Disconnect the red and the gray wires of the device
from the «plus» wire they have been initially
connected to.
6. Connect the red wire to the power supply circuit
(DO NOT connect the gray wire anymore).
