21
Alignment with TOR
Only single TOR may be added to the IGLA ALARM
system.
1. Connect both of the devices according to the wiring
diagrams described in their manuals (do not connect
the red and the gray wires of the TOR).
Alignment of the IGLA and the TOR should be
fulfilled without having the orange (status output),
yellow (ignition), violet, green and white-black/
white‑brown (analog blocking) wires connected.
2. Transfer the IGLA ALARM system to the PIN-code
change mode by one of the next ways:
• Connect the red and the gray wires of the IGLA
ALARM to a «plus»-wire in the car
• In the case the device has already been set up,
enter the valid PIN-code
1
once again when the
accelerator is fully pressed
2
.
If the current PIN-code involves slight push of the
accelerator, enter the PIN-code once again and
after that press the accelerator to the floor.
3. Twist the red and the gray wires of the TOR relay
together and connect it to a «plus»-wire in the car
(the IGLA ALARM system will signalize twice
3
).
1 The initial PIN-code adjustment algorithm is described on page
number 27.
2 A different operative organ is used in some of the cars instead of the
accelerator (see the official website https://service.author-alarm.com/).
3 The indication signals can be repeated until the ignition is turned off
(depends on the firmware version).
!
!
!
