22
4. Turn off the ignition in 3-5 seconds after the signals
have stopped and disconnect the red and the gray
wires from the «plus»-wire for restarting of the
device.
5. Connect the red wire of the device to the «plus»-wire
again (do not connect the gray wire anymore).
Alignment with the CONTOUR-module
1. Connect both of the devices according to the wiring
diagrams described in their manuals (do not connect
the red and the gray wires of the CONTOUR-module).
2. Transfer the IGLA ALARM system to the PIN-code
change mode by one of the next ways:
• Connect the red and the gray wires of the IGLA
ALARM to a «plus»-wire in the car;
• In the case the device has already been set up,
enter the valid PIN-code
1
once again when the
accelerator is fully pressed
2
.
When tying two or more devices to the IGLA ALARM,
the alignment should be conducted in the PIN-code
change mode by entering the valid PIN- code once
again. If the gray wire is used for alignment of the
devices, all the devices added sooner will be untied.
When adding the next device, all the previously
added devices should be disconnected from the
CAN‑bus.
1 The initial PIN-code adjustment algorithm is described on page
number 27.
2 A different operative organ is used in some of the cars instead of the
accelerator (see the official website https://service.author-alarm.com/).
!
!
