![background image](http://html1.mh-extra.com/html/radal-technology/csa-pod24/csa-pod24_product-installation-manual_3201079001.webp)
WIRING CONNECTIONS
If you are using a power supply, then decide which product will be
the Master Unit of the system and connect a 9
-
24Vdc power supply
as shown opposite. This connection is continued through to every
device on the system to supply power. This will normally be the CSA
-
FSU installed outside the washroom area. You can connect up to 10
devices to the CSA
-
FSU as shown in the diagram opposite.
When any device generates an alarm condition, this will be relayed
to the Master Unit which will also generate an alarm condition
simultaneously. You can use any of the devices as a Master Unit, the
diagram opposite is by way of example only.
Use 7 x 0.2mm stranded alarm cable for all the connections
.
Once the wiring is complete and checked, switch on the power
supply at the mains. Each device will provide a message stating how
it is configured. If you have a gas (smoke) element, the device will
flash its LED for 2 minutes to normalise.
DO NOT TEST THE DEVICE UNTIL THE FLASHING STOPS.
Your system is now installed and running normally.
Use the above diagram to connect any of the SD Evolution products as a master unit to any of the satellite products.
SpeechPOD (Part No CSA
-
POD) is normally supplied with an
on
-
board infra red PIR motion sensor as its detection device.
You can however trigger the SpeechPOD by other sources
instead or in addition to the PIR motion sensor. Examples of
these may be:
Door Contact, Pressure mat, alarm output from security, fire
or Building Management Systems, or any other device that
has a Clean or Volt Free Output.
Simply connect the Normally Open (NO) contact across the TRIG IN and GND input. Each time the switch closes,
SpeechPOD will play its programmed message. Remember, SpeechPOD can be battery operated or powered from a 9
-
24Vdc power supply connected to the 9
-
24V IN and GND inputs.
For further information or assistance with our products, please contact our Technical Department by phone or email as
detailed below.
PRODUCT INSTALLATION GUIDE
FOR THE FOLLOWING PRODUCTS
Part No: CSA
-
POD24
Advanced SpeechPOD
Voice Warning System
Part No: CSA
-
FGS24
Cig
-
Arrête® Combined Flame,
Smoke and SpeechPOD
Part No: CSA
-
FSV24
Cig
-
Arrête® Combined
Flame and SpeechPOD
Part No: CSA
-
FSU24
Cig
-
Arrête® Combined
Flasher & Sounder Unit
Part No: CSA
-
FGV24
Cig
-
Arrête® Combined
Flame & Smoke Detector
Part No: CSA
-
FOV24
Cig
-
Arrête® Flame Detector
With Voice Sounder
Part No: CSA
-
GOV24
Cig
-
Arrête® Smoke Detector
With Voice Sounder
Part No: CSA
-
GSV24
Cig
-
Arrête® Combined
Smoke & SpeechPOD
Part No: CSA
-
DUAL24
Advanced SpeechPOD Dual
Voice Warning System