AUI bp-9000e, Owner'S Manual

Page: 11 / 80

AUI BP-9000E Owner's Manual
- 5 -
Note: Make sure the two tabs are plugged into the Soundproof Cover holes entirely, or else,
the Soundproof Cover would get stuck.
2.7 Installing the Ribbon cartridge
1. Make sure the printer is turned off.
Note: Don’t replace the ribbon cartridge when the power is on, or else, it may hurt you when it
suddenly start to work.
2. Open the printer cover.
3. Take out the ribbon cartridge, turn the ribbon feed knob in the direction of the arrow to remove any
slack from the ribbon so it is easier to install. (As Figure 2-7 shown)
4. Place ribbon cartridge into the cartridge holders on the right and left sides, ribbon should be in the
ribbon guide. Check and make sure the ribbon drive shaft on the left side of the cartridge holders
has plugged into the holes on the ribbon cartridge bottom. (As shown in Figure 2-8)
5. Turn the ribbon feed knob in the direction of the arrow to remove any slack from the ribbon.
6. Close the printer cover, pull the gap adjust lever to the proper position to get the best printing result.
L-angle hinge
Cartridge holders
Ribbon guide
Ribbon mask
Cartridge holders
Figure 2-6 Installing the soundproof cover
Figure 2-7 Ribbon cartridge
Figure 2-8 Installing the ribbon cartridge
Ribbon knob
Ribbon core
Ribbon cartridge