AudioCodes Media Pack MP-112, User Manual

Page: 266 / 486

SIP User's Manual 266 Document #: LTRT-65412
MP-11x & MP-124
Parameter Description
Web/EMS: Enable Busy Out Determines whether the Busy Out feature is enabled.
[EnableBusyOut]

[0]

Disable = 'Busy out' feature is not used (default).
[1]
When Busy Out is enabled and certain scenarios exist, the
device performs the following:
Enable = 'Busy out' feature is enabled.
A reorder tone (determined by FXSOOSBehavior) is played
when the phone is off-hooked.

Physically disconnected from the network (i.e., Ethernet
cable is disconnected).
These behaviors are performed upon one of the following
scenarios:

The Ethernet cable is connected, but the device can't
communicate with any host. Note that LAN Watch-Dog
must be activated (the parameter EnableLANWatchDog
set to 1).

The device can't communicate with the proxy (according
to the Proxy Keep-Alive mechanism) and no other
alternative route exists to send the call.

The IP Connectivity mechanism is enabled (using the
parameter AltRoutingTel2IPEnable) and there is no
connectivity to any destination IP address.

Notes:

The FXSOOSBehavior parameter determines the
behavior of the FXS endpoints when a Busy Out or
Graceful Lock occurs.

FXO endpoints during Busy Out and Lock are inactive.
Refer to the LifeLineType parameter for complementary
optional behavior.
Out-Of-Service Behavior
[FXSOOSBehavior]

Determines the behavior of undefined FXS endpoints and
all FXS endpoints when a Busy Out condition exists.

[0] None = Normal operation. No response is provided
to undefined endpoints. A dial tone is played to FXS
endpoints when a Busy Out condition exists.

[1] Reorder Tone = The device plays a reorder tone to
the connected phone / PBX (default).

[2] Polarity Reversal = The device reverses the polarity
of the endpoint, marking it unusable (relevant, for
example, for PBX DID lines). This option can't be
configured on-the-fly.

[3] Reorder Tone + Polarity Reversal = Same as 2 and
3 combined. This option can't be configured on-the-fly.
[4] Current Disconnect = The device disconnects the
current of the FXS endpoint. This option can't be
configured on-the-fly.
Note: This parameter is applicable only to FXS interfaces.