AudioCodes Media Pack MP-112, User Manual

Page: 149 / 486

Version 5.8 149 September 2009
SIP User's Manual 3. Web-Based Management
3.3.4.10 Configuring Endpoint Phone Numbers
The 'Endpoint Phone Number Table' page allows you to activate the device's ports
(endpoints), by defining telephone numbers for the endpoints and assigning them to Hunt
Groups and profiles.
Notes:
•
Each endpoint (i.e., channel) must be assigned a unique phone number.
In other words, no two endpoints can have the same phone number.
•
You can also configure the endpoint phone numbers using the ini file
table parameter TrunkGroup (refer to ''Number Manipulation and Routing
Parameters''
328 on page ).

To configure the Endpoint Phone Number table:
1. Open the ‘Endpoint Phone Number Table’ page ( Configuration tab > Protocol
Configuration menu > Endpoint Number submenu > Endpoint Phone Number
Figure 3-88: Endpoint Phone Number Table Page
page item).
2. Configure the endpoint phone numbers according to the table below. You must enter a
number in the 'Phone Number' fields for each port that you want to use.
3. Click the Submit button to save your changes, or click the Register or Un-Register
4. To save the changes to the flash memory, refer to ''
buttons to save your changes and to register / unregister to a Proxy / Registrar.
Saving Configuration''
167
on page
.
Table 3-26: Endpoint Phone Number Table Parameters
Parameter Description
Channel(s)
[TrunkGroup_FirstBChannel] ,
The device's channels or ports as labeled on the device's rear-
panel. To enable channels, enter the channel (port) numbers.
You can enter a range of channels by using the format [n-m],
where
[TrunkGroup_LastBChannel]
n represents the lower channel number and m the
higher channel number, e.g., [1-3] specifies channels (ports) 1
through 3.