AudioCodes Media Pack MP-112, User Manual

Page: 290 / 486

SIP User's Manual 290 Document #: LTRT-65412
MP-11x & MP-124
Parameter Description
CallerDisplayInfo 1 = Mark M.,0; ("Mark M." is sent as
Caller ID for Port 2)

Notes:

When FXS ports receive 'Private' or 'Anonymous' strings in
the SIP From header, the calling name or number is not
sent to the Caller ID display.

If the Caller ID name is detected on an FXO line (the
parameter EnableCallerID is set to 1), it is used instead of
the Caller ID name defined in this table parameter.

When the parameter CallerDisplayInfo_IsCidRestricted is
set to 1 (Restricted), the Caller ID is sent to the remote side
using only the SIP headers P-Asserted-Identity and P-
Preferred-Identity (AssertedIdMode).

To maintain backward compatibility, when the strings
‘Private’ or ‘Anonymous’ are entered in the parameter
CallerDisplayInfo_DisplayString, the Caller ID is restricted
and the value of the parameter
CallerDisplayInfo_IsCidRestricted is ignored.

The value of the parameter
CallerDisplayInfo_IsCidRestricted is overridden by the
parameter
SourceNumberMapIp2Tel_IsPresentationRestricted in the
'Source Number Manipulation' table (table parameter
SourceNumberMapIP2Tel).

For an explanation on using ini file table parameters, refer
to ''
For configuring this table using the Web interface, refer to
Configuring Caller Display Information on page
144 .
Format of ini File Table Parameters'' 191 on page .
Enable Caller ID
[EnableCallerID]

Determines whether Caller ID is enabled.

[0] Disable = Disable the Caller ID service (default).
[1] Enable = Enable the Caller ID service.
If the Caller ID service is enabled, then for FXS interfaces,
calling number and Display text (from IP) are sent to the
device's port.
For FXO interfaces, the Caller ID signal is detected and sent to
IP in the SIP INVITE message (as 'Display' element).
For information on the Caller ID table, refer to Configuring
Caller Display Information on page
144 .
146
To disable/enable caller ID generation per port, refer to
Configuring Call Forward on page
.
Web: Caller ID Type
EMS: Caller id Types
[CallerIDType]

Defines one of the following standards for detection (FXO) and
generation (FXS) of Caller ID, and detection (FXO) generation
(FXS) of MWI (when specified) signals:

[0] Standard Bellcore = Caller ID and MWI (default)

[1] Standard ETSI = Caller ID and MWI

[2] Standard NTT

[4] Standard BT = Britain

[16] Standard DTMF Based ETSI
[17] Standard Denmark = Caller ID and MWI