AudioCodes Media Pack MP-112, User Manual

Page: 285 / 486

Version 5.8 285 September 2009
SIP User's Manual 6. Configuration Parameters Reference
Parameter Description
easily identify them later.

To use the settings of the corresponding global parameter, enter the
value -1.

To apply default settings to a parameter, enter two adjacent dollar signs
($$).

For a detailed description of each parameter, refer to its corresponding
"global" parameter.

For a description of using ini file table parameters, refer to ''Format of ini
File Table Parameters'' 191 on page .
6.7.4 Voice Mail Parameters
The voice mail parameters are described in the table below. For detailed information on the
Voice Mail application, refer to the
CPE Configuration Guide for Voice Mail .
Note: Voice Mail is applicable only to FXO interfaces.
Table 6-32: Voice Mail Parameters
Parameter Description
Voice Mail Interface Enables the device's Voice Mail application and determines the
communication method used between the PBX and the device.
[VoiceMailInterface]

[0]

None (default)
[1]

DTMF
[2] SMDI
Notes:

To enable voice mail per Hunt Group, you can use a Tel Profile ID
that is configured with voice mail interface enabled. This eliminates
the phenomenon of call delay on lines

For detailed information on voice mail configuration, refer to the
not implementing voice mail
when voice mail is enabled using this global parameter.
CPE Voice Mail Configuration Guide .
Line Transfer Mode
[LineTransferMode]

Determines the call transfer method used by the device.

[0] None = IP (default).

[1] Blind = PBX blind transfer. After receiving a REFER message
from the IP side, the FXO sends a hook-flash to the PBX, dials the
digits (that are received in the Refer-To header), and then
immediately drops the line (on-hook). The PBX performs the
transfer internally.
[2] Semi Supervised = PBX Semi-Supervised transfer. After
receiving a REFER message from the IP side, the FXO sends a
hook-flash to the PBX, and then dials the digits (that are received
in the Refer-To header). If no Busy or Reorder tones are detected
(within approximately 2 seconds), the device completes the call