AudioCodes Media Pack MP-112, User Manual

Page: 248 / 486

SIP User's Manual 248 Document #: LTRT-65412
MP-11x & MP-124
Parameter Description
EMS: OCSP Default
Response Determines the default OCSP behavior when the server cannot be
contacted.
[OCSPDefaultResponse]

[0]

= Rejects peer certificate (default).
[1] = Allows peer certificate.
6.5 RADIUS Parameters
The RADIUS parameters are described in the table below. For detailed information on the
supported RADIUS attributes, refer to ''Supported RADIUS Attributes'' on page
417 .
Table 6-27: RADIUS Parameters
Parameter Description
Enable RADIUS Access Control Determines whether the RADIUS application is enabled.
[EnableRADIUS]

[0]

Disable = RADIUS application is disabled (default).
[1] Enable = RADIUS application is enabled.
Note:
Accounting Server IP Address
For this parameter to take effect, a device reset is required.
IP address of the RADIUS accounting server.
[RADIUSAccServerIP]
Accounting Port Port of the RADIUS accounting server.
The default value is 1646.
[RADIUSAccPort]
Web/EMS: RADIUS Accounting
Type Determines when the RADIUS accounting messages are sent to
the RADIUS accounting server.
[RADIUSAccountingType]

[0]

At Call Release = Sent at call release only (default).
[1]

At Connect & Release = Sent at call connect and release.
[2]
Web: AAA Indications
EMS: Indications
At Setup & Release = Sent at call setup and release.
Determines the Authentication, Authorization and Accounting
(AAA) indications.
[AAAIndications]

[0]

None = No indications (default).
[3]
Device Behavior Upon RADIUS
Timeout
Accounting Only = Only accounting indications are used.
Defines the device's response upon a RADIUS timeout.
[BehaviorUponRadiusTimeout]

[0]

Deny Access = Denies access.
[1] Verify Access Locally = Checks password locally (default).
Number of concurrent calls that can communicate with the
RADIUS server (optional).
The valid range is 0 to 240. The default value is 240. [MaxRADIUSSessions]
Number of retransmission retries.
The valid range is 1 to 10. The default value is 3. [RADIUSRetransmission]
Determines the time interval (measured in seconds) the device
waits for a response before a RADIUS retransmission is issued.
The valid range is 1 to 30. The default value is 10. [RadiusTO]