AudioCodes Media Pack MP-112, User Manual

Page: 197 / 486

Version 5.8 197 September 2009
SIP User's Manual 5. Element Management System (EMS)
3. Type cf set
Enter data below. Type a period (.) on an empty line to
finish.
, and then press Enter; the following prompt is displayed:
The configuration session is now active and all data entered at the terminal is parsed
as configuration text (formatted as an
ini
4. Type the following at the configuration session:
file).
[ IPSEC_IKEDB_TABLE ]
FORMAT IKE_DB_INDEX = IkePolicySharedKey;
IPSEC_IKEDB_TABLE 0 = <IKE_password>;
[ \IPSEC_IKEDB_TABLE ]
[ IPSEC_SPD_TABLE ]
FORMAT SPD_INDEX = IpsecPolicyRemoteIpAddress,
IpsecPolicyLocalIpAddresstype;
IPSEC_SPD_TABLE 0 = <IP Address>,0;
[ \IPSEC_SPD_TABLE ]
EnableIPSec = 1
where:
•
<IKE_password> is the password for the initial IKE pre-shared key.
•
<IP Address> is the IP address of the EMS server used for connecting to the
device for which IPSec connectivity is established.
5. To end the PuTTY configuration session, type a full-stop (“.”) on an empty line; the
device responds with the following:
INI File replaced
6. To save the configuration to the non-volatile memory, type sar ; the device reboots with
IPSec enabled.
Note: If you have enabled IPSec and you want to change the IP address and/or IKE
password, you need to first disable IPSec. Perform the procedure as above,
but omit the lines IPSEC_IKEDB_TABLE 0 and IPSEC_SPD_TABLE 0, and
set EnableIPSec to 0. Once you have done this, repeat the exact procedure
as described above, but with the new IP address and/or password.