AudioCodes Media Pack MP-112, User Manual

Page: 322 / 486

SIP User's Manual 322 Document #: LTRT-65412
MP-11x & MP-124
Parameter Description
Charge Codes Table This
[ChargeCode]
ini file table parameter configures metering tones (and their time
intervals) that the device's FXS interface generates to the Tel side.
The format of this parameter is as follows:
[ChargeCode]
FORMAT ChargeCode_
Index = ChargeCode_ EndTime1 ,
ChargeCode_ PulseInterval1 , ChargeCode_ PulsesOnAnswer1 ,
ChargeCode_ EndTime2 , ChargeCode_ PulseInterval2 ,
ChargeCode _PulsesOnAnswer2 , ChargeCode_ EndTime3 ,
ChargeCode_ PulseInterval3 , ChargeCode_ PulsesOnAnswer3 ,
ChargeCode_ EndTime4 , ChargeCode_ PulseInterval4 ,
ChargeCode_ PulsesOnAnswer4
Where,
;
[\ChargeCode]

EndTime = Period (1 - 4) end time.

PulseInterval = Period (1 - 4) pulse interval.

PulsesOnAnswer = Period (1 - 4) pulses on answer.
For example:
ChargeCode 1 = 7,30,1,14,20,2,20,15,1,0,60,1;
ChargeCode 2 = 5,60,1,14,20,1,0,60,1;
ChargeCode 3 = 0,60,1;
ChargeCode 0 = 6, 3, 1, 12, 2, 1, 18, 5, 2, 0, 2, 1;

The parameter can include up to 25 indices (i.e., up to 25 different
metering rules can be defined).
Notes:

This parameter is applicable only to FXS interfaces.

To associate a charge code to an outgoing Tel-to-IP call, use the
'Tel to IP Routing' table.

To configure the Charge Codes table using the Web interface, refer
to ''Configuring the Charge Codes Table''
116 on page .

For an explanation on configuration using ini file table parameters,
refer to ''Format of ini File Table Parameters'' 191 on page .
6.12 Telephone Keypad Sequence Parameters
The telephony keypad sequence parameters are described in the table below.
Table 6-50: Keypad Sequence Parameters
Parameter Description
Call Pickup
[KeyCallPickup]
Defines the keying sequence for performing a call pick-up. Call
pick-up allows the FXS endpoint to answer another telephone's
incoming call by pressing this user-defined sequence of digits.
When the user dials these digits (e.g., #77), the incoming call
from another phone is forwarded to the FXS user's phone.
The valid value is a string of up to 15 digits (0-9, #, and *).

Notes:

Call pick-up is configured only for FXS endpoints pertaining
to the same Hunt Group ID.
This parameter is applicable only to FXS interfaces.