5
Type in the IP address of your ATEM switcher in the “Switcher Address” field. Your
ATEM switcher defaults to a fixed IP address of 192.168.10.240 when shipped and this
is the number you should type in this field unless you have changed it.
6
“Set tally outputs” should be set to “Switcher Inputs 1-8” unless you are configuring
a second unit to provide tally outputs for switcher inputs 9-16 of an ATEM 2 M/E
Production Switcher.
7
Click “Apply”. The white LED to the right of the USB port should stop flashing and
remain on to indicate it has successfully found the ATEM switcher. The GPI and Tally
Interface is now ready.
8
Close Blackmagic ATEM Setup and disconnect your USB cable.
Network and Tally Settings for the GPI and Tally Interface
185
Using Tally