AT&T administration and, Installation And Maintenance Manual

Page: 232 / 404

you want to designate a new attendant position and the
system already has the maximum number, you
must
change an existing attendant position to a nonattendant
voice terminal before you designate the new attendant
position.
With a Display Console
1
2
3
4
5
6
7
Press [System], [Attendnts].
Press
[Position].
Enter administration mode by sliding the T/P switch to
P.
Press Conference twice.
The administration menu appears.
Press the Auto Intercom buttons of the stations you
want to designate
as
attendant positions until their
green lights show the appropriate code:
Slteady green light = attendant position
Flashing green iight = potential attendant position used
as
nonattendant voice
terminal
Green
light off
= cannot be assigned as attendant position
Press
[Store].
The message "System is Re-staring...” appears. When the process
is complete, after a short delay, the administration menu appears.
Continue administration or leave administration mode
by sliding the T/P switch to the center position.
With a BIS-34D Console
1 Enter administration mode by sliding the T/P switch to
P.
2 Press Conference twice.
Lights
flash next to Adm
Tel, Adm Pool, Message, and Speaker.
3 Press Message.
Light goes on steady
next to
Message. Flashing
lights
go off.
3-24 Administering a New System