ASV SC50 Scout, Service & Repair Manual

Page: 74 / 111

4. Remove the bolts securing the tailpipe to the chas-
sis opening as shown. (fig. 11-8)
5. You may now remove the exhaust tail pipe from
the machine. (fig. 11-9)
Note: The exhaust gasket(s) should be replaced
whenever this joint is disassembled. (fig. 11-9)
6. Loosen and remove the exhaust clamp securing
the flex-joint section of pipe to the header down-
tube. (fig. 11-10)
Note: Thoroughly coat all clamped exhaust pipe joints
(make sure they are cool) with a penetrating lubricant
prior to attempting to separate the pipe sections from
each other. This will make removal significantly easier.
7. Slide the jointed section of pipe off of the header
down tube and remove. (fig. 11-11)
Note: Use caution not to damage the pipe or connec-
tion point during removal.
8. Remove the pipe section from the machine as
shown. (fig. 11-12)
Note: If the individual sections of the jointed pipe need
to be separated, use a pliers to remove the springs
that hold them together, then separate them as
required.
Installation
1. To install the exhaust system, reverse the removal
procedure.
11-3
Rubber Track Utility Vehicle
11. Engine
11-10
11-11
11-8
11-9
11-12
https://tractormanualz.com/