ASV SC50 Scout, Service & Repair Manual

Page: 33 / 111

To install tracks:
1.
Wrap the track around the sprocket at the rear of
the undercarriage (fig. 4-39).
2. Lubricate the inner front 14” wheel and the inside of
the track at the front to aid in sliding the track back
onto the undercarriage (fig. 4-40, 4-41). Wipe the
axles clean (fig. 4-42).
3. Install outer 14” wheel into the track between the
drive lug rows, then pull or pry the wheel forward to
line it up with the axle, then slide it onto the axle as
you slide the track over the inner 14” wheel. Once
on the axle, tap the wheel gently inward into
position (see note below) (fig. 4-42, 4-43).
Note: It is important to carefully align the wheel center
with the axle prior to sliding it on to avoid damaging
the inner seal during installation.
Note: If for some reason your machine is higher off of
the ground than recommended, you may need to raise
the lower portion of the track upwards towards the
undercarriage in order to gain the slack needed to per-
form step 3.
4-12
Rubber Track Utility Vehicle
4. Maintenance
4-39
4-40
4-41
4-42
4-43
4-44
4-45 Marks
https://tractormanualz.com/