Chapter 2: Hardware setup
-
2. Push the back side of the top
cover panel backward until it is
half inch away from the front
upper cover panel.
1/2 inch distance
3. Remove the back top cover panel.
2.1.3 Install the rear cover
1. Locate the grooves (see the
figure). Push the top cover panel
toward the front panel.
Match the upper cover panel to the
grooves on the left and right sides.
2. Match the clips of the top cover
panel with the grooves (see the
figure), and then clinch. Leave
a half inch distence between
the front edge of the top cover
panel and the real panel.
firmly clinched
match the clips and the grooves
3. Fasten the two screws as shown below.
screws
Summary of Contents for RS162-E4 RX4
