Asus RS162-E4 RX4, User Manual

Page: 32 / 164

Chapter 2: Hardware setup
-1
1. Follow the steps 1-2 on the last
page to remove the riser card. Using
a cross screw driver to remove the
screws on the bracket.
2.Insert the PCI Express card into
the slot, and then secure it with the
screws.
To install a PCI Express x8 card: (the slot supports PCI-E x8, x4 and x1
cards)
1. Take note of the holes on the
riser card bay. The two pegs on
the riser card bracket should
match these holes ensure that
the bracket is properly in place.
2.5.2 Reinstall the riser card
To reinstall the transfer card:
2. Insert the PCI riser card with the installed expansion cards into the PCI
riser card slot on the board. Make sure the golden fingers are completely
inserted into the slots and the mental barcket is properly matched with
the rear panel.
PCI Express x8