73
ASSA ABLOY Hospitality
66 8003 016-3
To add the lock to the in-room network
The in-room network is configured under the
Configure device
section in Orion
Service.
Configuration
Description
Form new
network
This configuration removes all nodes in the PAN and resets
the coordinator.
Permit join
When this configuration is used, an in-room device (RF door
switch, motion sensor or lock) can join the coordinator.
Forbid join
When the RF door switch, motion sensor or lock has joined
the coordinator, this configuration should be used on the
coordinator.
Note:
If the
Forbid join
command is for some reason
forgotten, it will automatically be executed 15 minutes after
the
Permit join
command was executed.
Set channels
Default is that all channels are ON (the '1' indicates ON);
the best channel will automatically be chosen, so normally
the
Set channels
command is not needed.
Get network
This configuration shows the in-room network.
Note:
When hovering with the cursor over an item in the
network, the tooltip will show what type of item it is; e.g.
'Coordinator' as in the screenshot example above. The
tooltip will also show e.g. IEEE address and firmware
version.
Table D1
1.
Go to
Start/Programs/
Orion Service/Orion Service
.
2.
Choose
Configure device
in the
left pane of the Orion Service
window.
3.
Plug the service cable into
the thermostat.
4.
Choose the
Coordinator
tab.
5.
Click
Form new network
.
Figure D2
