AsGa LightBolt 28304-E1, User Manual

Page: 83 / 100

AsGa Light AsGa Light AsGa Light AsGa LightBOLT BOLT BOLT BOLT 10GigE Switch 10GigE Switch 10GigE Switch 10GigE Switch
U U U User Guide ser Guide ser Guide ser Guide Configuration Configuration Configuration Configuration
83
2c Traps version 2
community : Set the community string for
SNMPv1/v2c transactions
community Communnity string
3
Traps version 3
noauth No authorization
auth
Authorization
priv Privative
username
Username
udp-port
Set the port to send SNMP traps
port
UDP Port number
Command Mode
Config mode
Usage
LightBOLT(config)# snmp-server manager
ip-address
( traps-version ( 1 | 2c | 3 user
username
( auth | noauth | priv ) | ) ( community
string
| ) ( upd-port
port
| )
Examples
LightBOLT(config)# snmp-server manager 192.168.1.1 traps-version 1 community AsGa
upd-port
162
LightBOLT(config)# snmp-server manager 192.168.1.1 traps-version 2c community AsGa
upd-port 162
LightBOLT(config)# snmp-server manager 192.168.1.1 traps-version 3 user ASGA auth
community AsGa upd-port 162
Related Commands
5.1.35 snmp-server trap-source
This command specify the interface (with the corresponding IP address) from which a
Simple Network Management Protocol (SNMP) trap should originate, use the snmp-server trap-
source
command in global configuration mode. To remove the source designation, use the
no
form
of the command.
Command Syntax
snmp-server trap-source <IFNAME>
IFNAME:
is any valid interface with a valid IP address
Command Mode
Exec mode
Usage
LightBOLT(config)# snmp-server trap-source <IFNAME>