AsGa Light
AsGa Light
AsGa Light
AsGa LightBOLT
BOLT
BOLT
BOLT 10GigE Switch
10GigE Switch
10GigE Switch
10GigE Switch
U
U
U
User Guide
ser Guide
ser Guide
ser Guide
Configuration
Configuration
Configuration
Configuration
14
console port on the switch; or remotely by a Telnet or SSH connection over the network. For any
remote operation you need to configure an IP management address. The IP address for this switch is
unassigned by default. To change this
address, see “
Setting Management IP address
” on page 22.
The switch, CLI interface configuration program agent allow you to perform the following
management functions:
•
Set user names and passwords.
•
Set an IP interface for a management VLAN.
•
Configure SNMP parameters.
•
Enable/disable any port.
•
Set the speed/duplex mode for any port.
•
Configure up to 4096 IEEE 802.1Q VLANs.
•
Upload and download system software via TFTP.
•
Upload and download switch configuration files via TFTP.
•
Configure Spanning Tree parameters for all STPx supported.
•
Enable port mirroring.
•
Set broadcast storm control on any port.
•
Display system information and statistics.
•
Others.
3.12 Connecting to the switch
3.12.1 Local Configuration
The switch provides an RS-232 serial port that enables a connection to a PC or terminal for
monitoring and configuring the switch. To do this you will need a RS232 (no cross over cable) cable;
attach a VT100-compatible terminal or a PC running your favorite terminal emulation program with the
following parameters configured:
•
Select the appropriate serial port (COM port 1 or COM port 2).
•
Set to the profile to the default switch profile.
•
Once you have set up the terminal correctly, the console login screen will be displayed.
•
Refer to “Line Commands” for a complete description of console configuration options.
The following picture show the DB9 switch “Pin out”:
3.12.2 Remote Connections
By default your LightBolt switch does not accept any remote configuration neither telnet nor
ssh. You need specifically enable those features trough configuration mode. The following lines
describe those commands in order to enable the Telnet service.
