AsGa Light
AsGa Light
AsGa Light
AsGa LightBOLT
BOLT
BOLT
BOLT 10GigE Switch
10GigE Switch
10GigE Switch
10GigE Switch
U
U
U
User Guide
ser Guide
ser Guide
ser Guide
Configuration
Configuration
Configuration
Configuration
51
Default
If this command is not used, Cisco interoperability is disabled.
Command Mode
Configure mode
Usage
If Cisco interoperability is required, all AsGOS boxes in the switched LAN must be Cisco-
interoperability enabled. When AsGOS is interoperating with Cisco, the only criteria used to classify a
region are the region name and revision level.VLAN to instance mapping is not used to classify
regions when interoperating with Cisco.
Examples
To enable Cisco interoperability on a Layer-2 switch for a particular bridge (bridge 2 in this example):
AsGOS# configure terminal
AsGOS(config)# bridge cisco-interoperability enable
To disable Cisco interoperability on a Layer-2 switch for a particular bridge:
AsGOS# configure terminal
AsGOS(config)# bridge cisco-interoperability disable
4.4.2 bridge instance priority
Set the bridge priority for an MST instance to the value specified. To restore the default
value of the bridge priority, use the
no
parameter with this command.
Command Syntax
bridge <1-32> instance INSTANCE_ID priority BRIDGE_PRIORITY
no bridge <1-32> instance INSTANCE_ID priority
<1-32>
Specify the bridge-group ID.
INSTANCE_ID
Specify the instance ID.
BRIDGE_PRIORITY <0-61440>
Specify the bridge priority (a lower priority indicates a greater
likelihood of the bridge becoming root).
Command Mode
Configure mode.
Default
The default value of the priority for each instance is 32768.
Usage
The lower the priority of the bridge, the better the chances are of the bridge becoming a root bridge or
a designated bridge for the LAN. The permitted range of values is 0-61440. The priority values can be
set only in increments of 4094.
