![AsGa LightBolt 28304-E1 User Manual Download Page 82](http://html1.mh-extra.com/html/asga/lightbolt-28304-e1/lightbolt-28304-e1_user-manual_2981900082.webp)
AsGa Light
AsGa Light
AsGa Light
AsGa LightBOLT
BOLT
BOLT
BOLT 10GigE Switch
10GigE Switch
10GigE Switch
10GigE Switch
U
U
U
User Guide
ser Guide
ser Guide
ser Guide
Configuration
Configuration
Configuration
Configuration
82
Examples
AsGOS# show user-priority interface eth0
Related Commands
5.1.33 Storm Control
To enable broadcast, multicast, or Destination Lookup Failure (DLF) storm control on a particular port,
use the
storm-control
command in interface configuration mode. To disable storm control for
broadcast, multicast, or DLF traffic, use the
no
form of this command.
Command Syntax
storm-control
< broadcast | dlf | multicast> < level>
broadcast
:
issue this key to limit the maximum broadcast traffic to be admitted by a specific port.
dlf
:
is the maximum throughput of dlf (destination lookup failure) to be forwarded/admitted by a
specific port. A dlf occur each time that a
no
MAC address match is accomplished.
multicast
:
use this key to limit the maximum multicast traffic to be admitted by a specific port.
level
:
specify the maximum level of the specific traffic admitted by a specific port. This level is
intended to be a % of the maximum speed of the port.
Command Mode
Interface mode
Usage
AsGOS(config-if)#storm-control broadcast <% of the maximum Speed Port>
Examples
AsGOS(config-if)#storm-control broadcast 30
AsGOS(config-if)#storm-control dlf 50
AsGOS(config-if)#storm-control multicast 10
Related Commands
5.1.34 snmp-server manager
Use the snmp-server host global configuration command to specify the recipient (host) of a
Simple Network Management Protocol notification operation. Use the no form of this command to
remove the specified host. UP to five host can be provisioned.
Command Syntax
snmp-server manager
ip-address
traps-version
( ( 1 | 2c )
community
community
| 3 ( noauth | auth | priv )
username
) (
udp-port
port |
)
snmp-server
Configure parameters to SNMP Agent
manager
Set manager configuration to send traps
ip-address
IP address of a manager
traps-version
Set the traps version
1
Traps version 1