AsGa Light
AsGa Light
AsGa Light
AsGa LightBOLT
BOLT
BOLT
BOLT 10GigE Switch
10GigE Switch
10GigE Switch
10GigE Switch
U
U
U
User Guide
ser Guide
ser Guide
ser Guide
Configuration
Configuration
Configuration
Configuration
27
Start-character:
Set the current start character used when software flow control mechanism
is
activate ( possible ASCII values are
1-255
)
Stop-character:
Set the current stop character used when software flow control mechanism
is
activate ( possible ASCII values are
1-255
)
Width:
Set the current screen column width valid values are
0-60
.
Length:
Set number of lines on a screen valid values are
0-512.
Privilege level
Change privilege level for line
<1-15>.
Escape-character:
Change the current escape character possible values are ASCII from
1-255.
To configure any of those parameters you must issue the following commands. The table
shows just some of those commands.
COMMAND
DESCRIPTION
AsGOS#
configure terminal
Enter the
Configure
mode.
AsGOS(config)#
line console
Enter in consolo configuration
mode.
AsGOS (config
)# speed <(115200|57600|38400|19200|9600|4800|2400)
Change the console speed.
AsGOS (config
)# parity (none|even|odd|space|mark)
Change the console parity.
AsGOS (config
)# flowcontrol (none|software (in|out)|hardware)
Change the console flow
control mode.
AsGOS (config
)# databits <5-8>
Change the console data bits.
AsGOS (config
)# exec-timeout <0-35791> (<0-2147483>|)
Change the Exec time out for
a session started from
console.
AsGOS (config
)# session-timeout <0-35791> (<0-2147483>|)
Change the session time out
for the console.
3.16.2 Enabling Telnet connections and SSH connections
In order to enable those services on your LightBolt platform you need specifically configure
it. If not configures those services will not be available for external connections.
Service Telnet {Enable | disable}
Service SSH {enable | Disable}
COMMAND
DESCRIPTION
AsGOS#
configure terminal
Enter the
Configure
mode.
AsGOS(config)#
service SSH enable
Enable SSH service.
AsGOS(config)#
service telnet enable
Enable Telnet Service.
Disabling Telnet or SSH services:
COMMAND
DESCRIPTION
AsGOS#
configure terminal
Enter the
Configure
mode.
AsGOS(config)#
service SSH disable
Disable SSH service.
AsGOS(config)#
service telnet disable
Disable Telnet Service.
Telnet connection setting.
