TD 92483GB
2008-06-05/ Ver. B
Installation and Operation Manual
UPAC- Unite Packet for Messaging and Alarm
51
1
Click “Add Email” to define an e-mail to send.
2
Enter e-mail addresses and any addresses that should receive a copy.
3
Enter a subject and a message text.
4
Select the
Include log info
check box to add the fault information to the message
text.
SNMP Trap Action
1
Click “Add SNMP trap” to define a SNMP trap to send.
2
Enter the IP address that the trap is to be sent to.
3
Enter the text that should be sent.
4
Select the
Include log info
check box to add the fault information to the message
text.
5
Select SNMP version.
6
To send another SNMP trap, click “Add SNMP trap” again.
Output Action
1
Select the output to be activated and click “Add”.
The outputs are configured on the
I/O Setup
on page 18. The state is set to the opposite of the inactive state when activated. For
example, if output 2 is set to low in inactive state, the output will automatically be
set to high when activated.
2
Set the duration in seconds. If the
Persistent Action
check box is selected, the
Duration
field can be left empty.
The output can be manually reset from the
I/O setup
page.
3
Select the
Persistent Action
check box to activate the output as long as the
persistent fault remains. If not selected, the output will be active for the set
duration also for persistent faults.
Error Relay Action
1
Select the
Indicate Fault
check box if the error relay should indicate faults.
2
Set the duration in seconds. If the
Persistent Action
check box is selected, the
Duration
field can be left empty.
The error relay will be released when activated. The error relay can be manually
reset from the
Active Faults
page.
3
Select the
Persistent Action
check box to activate the relay as long as the persistent
fault remains. If not selected, the relay will be active for the set duration also for
persistent faults.
BusLogger Action
The Windows application BusLogger is used for error tracking in System 900 and Unite
systems. An action in the Fault Handler can trigger the BusLogger to save current log
information to disk, to prevent it from being overwritten.
Select the check box to make the BusLogger tool save current log information when the
trigger is matched.
