TD 93021US
17 July 2017 / Ver. PF3
41
Installation Guide
teleCARE IP
5.7.3 Installing the LED Lamp Boards on the IP Room Controller Board
On the back side of the IP room controller PCB there are the four sets of through-board connections for
the LED lamp boards. Each through-board connector has three holes which accept the three connecting
pins on the LED lamp board.
Figure 48. LED through-board connectors and guide marks
The LED lamp connection points are labeled LED0, LED1, LED2, and LED3. Any color LED board can be
plugged into any of the connection points in the IP room controller. The appropriate position of the LED
color is determined during the system setup.
Caution:
The pins on the LED lamp board are not in the center of the board so it is important
to make sure that the LED lamp board lines up with the guide marks on the IP room controller
PCB when the pins are inserted.
Figure 49. Plugging LED lamp board into the room controller PCB
LED Lamp Board
Guide Marks
Through-Board Connection Holes
for the LED Lamp Boards
Insert the pins of the LED lamp board in
the holes in the Room Controller PCB
Align the LED Lamp Board
with the Guide Marks on the
Room Controller PCB
