TD 93021US
17 July 2017 / Ver. PF3
169
Installation Guide
teleCARE IP
9.6
Duty Selector at a staff Station
The Duty Selector is an peripheral which can be connected to any one of the four room buses from the
room controller. It has a fixed address number 5 on the room bus which cannot be changed.
It also has two inputs and two galvanically isolated outputs via relays. The two input circuits and the two
output circuits are available as interfaces to external devices. These inputs and outputs can be controlled
over the LAN via the room controller.
The duty selector is typically located at the staff station (as shown in the illustration below) where it is
used to select the call forwarding groups and response sequences according to the duty configurations
which have been configured in the system setup.
Figure 183. Staff station with duty selector and door side module
IMPORTANT:
A room controller (not a corridor lamp) must be installed at the staff station
for room fault and LAN fault signaling.
