artisan TRACKPOINT 3 4211A, Operation And Maintenance Manual

Page: 23 / 253

TRACKPOINT 3 GENERAL INFORMATION
1-8
Sequential or Consecutive Tracking Up to 4 Targets
DIFF KEY INPUT – RESPONDER (4)
Via rear panel Synchronization connector Accepts single ended or differential signal input to an opto-
coupler.
pulse widths min = 200 micro-seconds
pulse width max = up to the width of the transmit-out burst
TRIGGER OUT
Via rear panel Synchronization connector Sync for Responder operation;
Differential Output (0-5VDC) Either side can be used as a
positive or negative TTL pulse when used with GND.
ANALOG INPUTS
Analog Voltage input for Depth Uni-polar 0-6VDC
Analog Voltage input for Compass Uni-polar 0-6VDC
Analog Voltage input for Pitch & Roll ±10VDC input
Absolute Accuracy (±10VDC, -10 ° to 50 ° C) 0.27%
Resolution of A/D Converter
A/D converter = 16-bits
SIGNAL INTERFACE MODULE RS-232
PORTS
Comport #1 Used for Communications with Processor Module for setup
of parameters and sending of target data.
Comport #2 Compass Input, typically
Comport #3 GPS Input for timing, typically
1-PPS INPUT
Via rear panel BNC Accepts a 1-PPS trigger from GPS ; Opto-coupler input. (fu-
ture)
SIGNAL INTERFACE MODULE TRANS-
MITTER SPECS
Frequency 8 - 30kHz in 500Hz increments
Pulse Width 1-15ms in 0.1 ms increments
Repetition Rate 0.5 to 20 seconds
Output Power 100 or 400 Watts into 300 Ω Load
Sound Pressure Level 17-20kHz, @ 400W - Nominal 192dB re 1 µ Pa @ 1m