Arthrex Angel, Operator'S Manual

Page: 23 / 108

Overview
Angel ® cPRP System Operator’s Manual
1-5
Unpacking Tip: Check the Pump Rotor Installation:
a. The Pump Rotor is spring-loaded onto the rotor motor shaft.
b. Check to make sure the Pump Rotor is in the proper operational
position by gently pulling up on the rotor.
c. If it is loose:
d. Rotor is installed properly when it cannot be lifted from the rotor
housing.
2. Install the device in an operating environment between 10 and 30 degrees C (50-
86 degrees F), 10% to 70% relative humidity and 70 kPa to 106 kPa pressure.
3. Place the Angel System on a solid, flat work surface.
4. Install the Power Cord Assembly supplied with the equipment into the
Angel System . Plug the power into an available power outlet.
PRECAUTION
There are no user-serviceable parts inside this device. To avoid the risk
of electrical shock, do not remove the cover. Refer all servicing to
qualified service personnel.
NOTE: Due to the possibility of operator exposure to blood borne
pathogens (such as HIV, hepatitis viruses, bacteria, etc.), Universal
Precautions for blood borne pathogens should be practiced (e.g., gloves,
Personal Protective Equipment PPE), etc.).