Artesyn Embedded Technology 6806800R89E, Assembly, Installation And Use

Page: 85 / 118

SharpMedia PCIE-8120 Hardware Description
SharpMedia™ PCIE-8120 Installation and Use (6806800R89F)
85
B.8.2.6 Debug LED
The card provides 8 Debug LEDs to the CPLD to indicate the power-up status and generic fault
conditions. The LEDs 0-7 are located on the top component side of the card near the PCI
Express connector, oriented from left to right. In default run state, all LED are off. For LED error
codes see the table below:
Table B-2 Sensor alert default values
Sensor type Minor Major Critical
Inlet Temp >50°C >55°C >60°C
Outlet Temp >55°C >70°C >80°C ***
Delta Temp <5°C * >15°C > 0°C
Card Power 12 OCT 60W@12V 65W@12V 70W@12V
Supply Bus voltage < 11.5V < 10 V < 9V
Supply Bus current 4 OCT 1.8A ** 2.1A ** 2.5A **
Supply Bus current 12 OCT >5 Amp >6.5 Amp >7 Amp
Card Power 4 OCT 22W@12V 26W@12V 30W@12V
Card Power 12 OCT -N**** 60W@12V 78W@12V 84W@12V
* A low delta temperature reflects poor system cooling capability.
** It is not recommended to use current readings for alarms as they depend on
varying voltage. Use card power readings instead.
*** The
PCIE-8120 temperature sensors are pre-configured to shutdown the card
when either sensors reach 80 °C. The system can restart when the temperature falls
below 75 °C.
**** The higher sensor readings for -N version reflect exceptional operating
conditions per NEBS requirement.
Table B-3 LED Error Code (For 0, 1 and 2)
LED NUMBER
DESCRIPTION
2 1 0
Off Off Off Enable state-12V stable