Arjo Enterprise E8000X, Service Manual

Page: 50 / 105

Servicing Instructions Enterprise E8000X Service Manual
Page 46
12 Deck Junction Box - Replacement
This section describes how to replace the deck junction box. Reference is made throughout this section
to Figure 3 on page 29.
There are two deck junction boxes on either side of the bed frame. The deck junction boxes also contain
the under bed lights.
Figure 11: Deck junction box clips
12.1 Removal
To remove a deck junction box:
12.1.1 Referring to Figure 11 item A, Insert a small flat bladed screwdriver into the slots on the front
of the junction box (Fig 3, Item 13) to release the clips.
12.1.2 Pull off the faceplate and keep it safe.
12.1.3 Unplug the cables from the junction box, having first made a note of which cable is connected
to each socket. The left hand junction box has three cables connected to it, the right hand
junction box has four. Do not remove the blanking plug from the left hand junction box.
12.1.4 Referring to Figure 12, undo the two Ejot screws (Fig 3, Item 14) to release the junction box
from the bracket below the split side rail and remove it from the bed.
Figure 12: Deck juntion box Ejot screws
12.2 Installation
To install a deck junction box:
12.2.1 Position the junction box (Fig 3, Item 13) on the bracket below the split side rail, making sure
that the underbed light faces down and outwards. Attach the box with Ejot screws
(Fig 3, Item 14).
12.2.2 Plug the cables into the corresponding sockets on the junction box as noted previously. Make
sure the plugs are fully pushed into the sockets - the yellow sealing rings must not be visible.
12.2.3 Thread the cables through the holes in the faceplate. Press the faceplate into position on the
junction box until it "clicks" into place.
A